Speed Stacks Store
Home > Store > Products > How to attach the timer to your StackMat
     
  Go to the Speed Stacks Store for the U.S.  
     
  How to attach the Timer to your Generation 2 StackMat™  
 
 
  These directions refer to the new Generation 2 StackMat and Timer only.
     
 

Open your StackMat and lay it flat in front of you. Notice the two pre-drilled holes along the bottom?

Your StackMat has been pre-drilled to accept the detachable timer.

 
 
 
 

Your Timer "splits" apart.

The Timer unit is held together by magnetic pads located in each half.

Hold the Timer between your hands and gently pull apart at the "seam" (where the halves meet).

 
 
 
 
 

Position the bottom half of the timer underneath the StackMat.

Line up the protruding "pins" on the timer into the holes on the StackMat.

 

  
 
 
 

Position the top half of the timer on top the StackMat and timer bottom.

Line up the "pins" and magnetized pads on the Timer and snap together.

   
  Activate the Timer by depressing the "Power" button on the faceplate and you are ready to time your stack.
 
         
       
           
  How to use the StackMat      
           
 
How to change the Timer's battery      
           
  Have the original StackMat? Click here for use instructions.      
           
         
 
 

Home | The Sport | Stacker News | Stacking Events | About Us | Speed Stacks Store
 
  Speed Stacks Japan
info@speedstacks.jp
Copyright© 2000-2007 Speed Stacks Japan / Speed Stacks, Inc.
All rights reserved.